Sor 536CR Low Power Pressure Transmitters Manual de usuario descargar pdf

Form 921 (03.13) ©SOR Inc.

1/8

These instructions provide information for installation, process connection,

electrical connection and field calibration of SOR

536CR Pressure

Transmitters. The 536CR Pressure Transmitter consists of a field-proven

pressure transducer and a reliable electronic circuit. The housing

features external adjustments and stainless steel construction.

NOTE: This instrument is non-repairable. If you suspect that it is defective,

contact the factory or the SOR representative in your area for a return

authorization number.

536CR

Low Power Pressure Transmitter

General Instructions

Registered Quality System to ISO 9001

Design and

specifications are

subject to change

without notice.

For latest revision, go to

www.sorinc.com

NOTE: If you suspect that a product is defective, contact the factory or the SOR Representative

in your area for a return authorization number (RMA). This product should only be installed by

trained and competent personnel.

Table of Contents

Installation ....................................... 1

Electrical Termination ..........................2

Calibration .......................................3

Dimensions ......................................4

Control Drawing .................................5

Installation

Ensure that wiring conforms to all applicable local and national

electrical codes and install unit(s) according to relevant national and

local safety codes.

Normally, line mounting provides adequate support for the instrument.

When the installation is complete, the external adjustments must be

accessible. (See

) Determine whether the process connection or

the electrical connection will be made first.

ection,

ven

eral

Instructions

Making the Process Connection First

The process connection is threaded onto a fitting within an adequately

supported process piping system. Use two open-end wrenches when connecting the

pressure port to a process piping system: one wrench to hold the hex flats of the pressure

connection, and the other to tighten the process fitting. Do not loosen the instrument

pressure port from the housing.

1 2 3 4 5 6 7 8

Indice de contenidos

Pagina 1 - Instructions

Form 921 (03.13) ©SOR Inc. 1/8These instructions provide information for installation, process connection, electrical connection and field calibration

Pagina 2 - Electrical Termination

2/8Form 921 (03.13) ©SOR Inc. Electrical TerminationMaking the Electrical Connection FirstThe electrical connection may be installed on an adequately

Pagina 3 - Calibration

Form 921 (03.13) ©SOR Inc. 3/8CalibrationTwo calibration screws (zero and span) are located underneath the adjustment cover. (See ) Loosen the cover

Pagina 4 - Dimensions

4/8Form 921 (03.13) ©SOR Inc. DimensionsLinear = mm/inchesDrawing 0090976Dimensions are for reference only.Contact the factory for certified drawings

Pagina 5 - Control Drawing

Pagina 7

Pagina 8 - Printed in USA www.sorinc.com

8/8Form 921 (03.13) ©SOR Inc. 14685 West 105th Street, Lenexa, KS 66215  913-888-2630  800-676-6794 USA  Fax 913-888-0767Registered Quality S

Comentarios a estos manuales

Sin comentarios

Sor 536CR Low Power Pressure Transmitters Manual de usuario

Busca en linea o descarga Manual de usuario para Sensores Sor 536CR Low Power Pressure Transmitters. SOR 536CR Low Power Pressure Transmitters User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Sor 536CR Low Power Pressure Transmitters